The IPEM PiHat is a HAT (Hardware Attached on Top) board for the Raspberry Pi that turns the single-board computer into a mains ... The system is easy to set up and does not require a professional ...

This module is based on the I2C light-to-digital converter TSL2561 to transform light intensity to a digital signal. Different from traditional analog light sensor, as Grove - Light Sensor, this ...

The UNO Mini Limited Edition encapsulates the spirit of the Arduino community, combining functionality with a unique, celebratory design. There is also another variant of Nana33 BLE available named ...

Optical sensors are a broad class of device for detecting light intensity. This can be just a simple component for notifying when ambient light levels rise above or fall below a prescribed level ...

Keeping your car secure needn’t be a difficult task. It can be as simple as anchoring it in place with a good wheel clamp. Devices like steering locks are another simple protection device, but a wheel ...

The current ratio is a liquidity ratio that measures a company’s ability to pay short-term obligations or those due within one year. It tells investors and analysts how a company can maximize ...

Abstract: This paper proposes a re-entrant optical fiber current sensor based on continuous light, which achieves continuous measurement while improving current measurement sensitivity. Based on the ...

The Current’s 20th Anniversary is here. Join us all year long as we celebrate the music that brought us together and keeps us together. Keep reading to find out more about the events and content ...

NXP Semiconductors has launched the MCX L series of ultra-low-power Arm Cortex-M33 MCUs with the MCX L14x and MCX L25x SKUs. The new series offers similar peripherals as the rest of the MCX portfolio ...

MagAlpha sensor detects the absolute angular position of a permanent magnet, typically a diametrically magnetized cylinder on the rotating shaft. Unlike most Arduino & Genuino boards, the MagAlpha ...

All these prints need to be pretty high-res so that they can withstand the pressure of the clamp holding it all together. [flowalistik] recommends a layer height no larger than .03mm and a 20% infill.