2004年5月30日 · I just got my Mcleod clutch put in and I drove it for about 30-40 miles yesterday and here is my first impressions~ Butter. Plain and simple. The shifts are flawless and the it really grabs well. No jerking or heavy foot petal. I highly recommend this clutch to anyone looking for a replacement. I got it for 360.00.

2009年6月29日 · McLeod RXT twin-disc clutch, Fidanza steel flywheel, 26-spline input shaft: After you remove the stock clutch/flywheel, it's a good idea to replace the pilot bearing. It easily came right out of the crankshaft with a puller, and we hammered in a new one.

2015年3月29日 · I just replaced my stock clutch with a new McLeod twin disc street clutch rated for 1000hp. The car is otherwise stock. The clutch chatter is insane vs stock. So much so that I have to launch at 3-4k all the time - incl in stop and go traffic - …

2017年2月4日 · Recently had a McLeod 26 spline street twin clutch kit, Tremec 26 spline input shaft, LP throwout bearing, Ford pilot bearing, and a UPR quick click firewall adjuster installed by a reputable speed shop. Drove the required 500 mile break in period. Now when I go into boost there is an abrupt jolt followed by a loss of power for a few seconds.

2011年11月20日 · I put in a McLeod RST clutch in my ride last weekend, and there is a really unhealthy noise when any power is added between 1000-1500 RPM in any gear except 5th. The sound is like a metallic gear clashing, and really sounds bad. The more power that is added, the louder the noise. Noise completely goes away above 1500 RPM.

2016年9月14日 · To remedy that problem, Team Lethal partnered with McLeod to develop an RXT 1200 twin-disc clutch to harness all that supercharged Voodoo power and channel it through the factory Tremec 3160 six-speed manual transmission. “So the GT350 clutch from McLeod needed to be designed from scratch.

2012年5月26日 · Well OEM clutch has outer bolts that hold the entire assembly to the flywheel. One time use torque to yield bolts that go to 35 ft/lbs and then 60 degrees. McLeod has a inner ring first that bolts down with ARP bolts that go to the flywheel and then the pressure plate gets held down with studs and nuts.

2017年5月21日 · Finally changed the clutch to the Extreme Street, and not only did it not cure the high rpm issues, it sucked to drive. The harder pedal was not a big deal, but it made noise and it released right off the floor. Pretty much an on or off clutch too. Not fun for street driving. The slave to pressure plate gap was not close to the factory clutch ...

2022年9月13日 · -McLeod RXT Clutch and Flywheel 6918-07-Ford Performance 4.6L/5.4L/5.8L & 5.0L TI-VCT Roller Pilot Bearing-McLeod Racing 1200 Series Hydraulic Slave Cylinder-OEM Master Cylinder Replacement-McLeod 139251 High Performance Hydraulic Clutch Line

2014年8月9日 · The 07-09 cars did have some sort of issue that I believe there was a recall or tsb for. The McLeod clutch requires the earlier slave to work. I have a spec. Didn't like it at first but after it broke in I do. It's a little stiffer than stock but they say the McLeod is like butter.